Clear protective polyurethane tape that can be applied directly over painted surfaces or decals to help prevent scratching, chipping or other damage. Use on inner wheel arches , wishbones, headlights, door shuts or anywhere added protection may be required. Tape is 0.2mm thick and provides excellent resistance to ultraviolet light and will not yellow over time.
51mm Wide x 9m Roll
Application Instructions:
PREPARATION:
For best results, apply at temperatures between 10-27 ° C. Surface must be clean and free of dirt and/or wax prior to application. Use sharp scissors to cut Surface Guard to size before removing liner, experiment with a small piece first.
DRY APPLICATION:
Remove paper liner slowly as Surface Guard is applied. Squeegee into position very slowly. The slower the better. Again, experiment first.
WET APPLICATION:
Spray a mixed solution of soap and water on the surface to be applied over. Remove the liner, apply, position into place and squeegee out bubbles. Any bubbles can be punctured with a scalpel. Allow 24 hours to dry.